ATEM tally light

Wireless tally light for use with ATEM switchers. Connects over WiFi using only a D1 mini board (ESP8266 WiFi module) and a RGB LED. This solution is not limited by the ATEM switchers’ connection limit, making it possible to connect as many as you need.

Should easily be convertable to use with regular Arduino boards and an ESP8266 module, by changeing the include statements and a few other things (however, this is not tested).

DIY guide is available in the wiki.

What does it do?

Once set up, it will automatically connect to an ATEM swithcer over WiFi and function as a tally light.

Once the program is uploaded to the ESP8266 the setup is done with a webpage it serves over WiFi where you are able to see status details, and perform the basic setup. Depending on if it’s connecting to a known network or not it will serve the webpage on it’s IP address, or on 192.168.4.1 (default) over a softAP (access point) named “Tally light setup”. For more detals, see the guide int the wiki.

As Atem swithcers only allow for 5-8 simultanious clients (dependant on the model) v2.0 introduced Tally Server functionality. This makes the system only require one connection from the switcher, as the tally lights can retransmit data to other tallys. An example setup is shown in the diagram below, where arrows indicate the direction of tally data from swtcher/tally unit to client tally unit.

Example_setup

NOTE: As this brings a lot of flexibility with how to connect the units, bear in mind that the ESP8266 isn’t that powerful, and is limited to 5 clients each. (In some cases 5 might even be too many).

Connection and tally state indication

The different states of connection is signalled with LED colors.

Color Description
BLUE Connecting to WiFi
WHITE Unable to connect to WiFi - serves softAP “Tally light setup”, while still trying to connect.
PINK Connecting to ATEM Swithcher. (Connected to WiFi)
RED Tally program
GREEN Tally preview
OFF Tally neither live or preview (or no power…)

Modes of operation

By default the tally light works as a normal tally light would in a professional enviroment. However, as I in my personal use case needed it to work a bit differently, I added the following modes of oparation for convenience.

Mode Description
Normal As describen in the above table.
Preview stay on Tally will be green whenever not in program
Program only Tally will be off whenever not in program

Use Arduino IDE with ESP8266 module

See details at ESP8266 on how to setup and use ESP8266 modules like a regular Arduino board. They have links for further documentation as well.

Credits

Based on ATEM libraries for Arduino by SKAARHOJ, available at Git repo: SKAARHOJ-Open-Engineering

Inspired by ATEM_Wireless_Tally_Light (However, this works completely different)